Electronics box mold

[termite]

I made this mold for my 22 wa to flush mount my electronics. I am selling the boat so I do not need it anymore. I was saving it in case I changed my electronics and needed a new one.

If anyone is interested, make me an offer.

This is a pic of the finished box.

[Eyekymo]

Termite, can you post the dimensions? Thanks, Mike

[termite]

The finished box is 22 wideX 13 front to back at the bottom X 11 high.

I will take a picture of the mold tomorrow and post it.

It is designed to fit the 22 wa helm. It comes to within 1" of the windshield and is curved on the right side. It will save you a lot of time and $ if you are good with glasswork.

[termite]

Here is the inside and outside of the mold

[Tony]

Maybe Cape Coral would be interested in it?

[Squid Row]

It is hard to tell from the pics, but how hard is it to see through the windshield over that box?

I really like the look of it though and might be interested..

[termite]

squid row, sitting down you can't see over it. I either stand up running the boat or sit in the center on long offshore runs. Not that bad. I like it better than bracket mounting the electronics. Gives it more protection. I glassed a wood block in each corner and screw it down from inside the cabin. In the winter I take out the 4 screws and take the box and the electronics right off. Just disconnect a few wires.

I made a locking cover when not in use.

[Tony]

Tom:

very smart looking! Is the blk vertical object below the morse controller, a heater vent?

[termite]

Tony, that's the circut breakers.